Display-devices Heavy Duty Projector Mount Manuel d'utilisateur télécharger pdf

1 6/24/05

Installation Instructions

PCM Stationary Mount

Ensure the ceiling structure is capable of holding at least four times the combined weight of the mount, pole

and projector. This is a minimum requirement; follow any local or state codes that apply to your specific area.

Ceiling Mount

Because projectors have different chassis’ (body style, location of lamp & cooling vents) the PCM may have

variations from these instructions. If you are mounting a projector in a facility with sheetrock or other hard

ceiling, follow the directions listed below. If the facility has a drop tile ceiling, skip to the POLE MOUNT section

for installation procedures.

1. Determine exact mounting location based upon the projector’s installation directions. Remove the Upper PCM

(1) by removing hex head hardware from the left and right side of the PCM. Be sure to retain this hardware

for reassembly later.

2. Attach the Upper PCM to the structural ceiling using slotted holes (5). Use appropriate hardware for the

ceiling material and weight involved. If rotational (yaw) adjustment is needed, you may leave this hardware

slightly loose for this purpose. Be sure to secure hardware when completing installation.

3. Mount the projector to the Lower PCM (2) with included hardware. Now reattach the lower PCM to the

Upper PCM using the previously removed hardware. Adjust for proper tilt and yaw, secure all hardware

3b. If your mount is quick release, unscrew the Thumbscrews (3) and remove the Interface Plate (4). Attach the

Interface Plate to the projector with the included hardware. Now reattach the Lower PCM to the Upper PCM

using the previously removed hardware. Attach the projector and Interface Plate with the Thumbscrews.

Adjust for proper tilt and yaw, secure all hardware

1 - Upper PCM

2 – Lower PCM

3 – Thumbscrews

4 – Interface Plate

5 – Mounting holes

1 – Tilt adjustment

2 – Pitch adjustment

1 2

1 6/24/05 Installation Instructions PCM Stationary Mount Ensure the ceiling structure is capable of holding at least four times the combin

Page 2

2 6/24/05 Pole Mount for Drop Tile Ceiling Mount Ensure the ceiling structure is capable of holding at least four times the combined weig

Pas de commentaire

Display-devices Heavy Duty Projector Mount Manuel d'utilisateur