tel: 303.412.0399 www.displaydevices.com fax: 303.412.9346 tech@displa
2 NOTE The lift is shipped fully assembled for installation into an unfinished ceiling application. To install in a finished ceiling, you must di
3 2.) Install the mounting plate using ½” hardware. Attach to structural channel or a solid mounting surface. Be sure the plate is leve
4 5.) Raise the lift to the mounting plate – insert the lugs into the key holes and slide to narrow side of key hole slot. 6.) Install the locking
5 Optional Speed Adjustment – Physical Installation The MicLift’s lowering and raising speed can be changed from slow to fast. The recommended sp
6 Electrical, Signal and Control Installation AC POWER Audio Signal Remote Control AC POWER 3 Pin XLR
7 Remote Control - Pin out 1 UP 2 DOWN 3 STOP 4 COMMON 5 12V trigger in 6 +5V out 1.) Remove the j-box cover plate and con
8 Programming Ramping Distance You may determine the location where the lift slows its acceleration. Programming can only be done with the three-
9 Optional Control Support The next two control methods involve adding jumper wires on the Phoenix connector in the center j-box. They are prese
Commentaires sur ces manuels